Device In The 5.25-Inch Flex Module - Lenovo ThinkStation P410 Hardware Maintenance Manual

7. Install the new card reader into the card reader slot from the rear of the front audio and USB assembly.
Then install the two screws to secure the card reader.
Note: Carefully handle the card reader by its edges.
Figure 81. Installing the new card reader
8. Install the front audio and USB assembly into the chassis. See "Front audio and USB assembly" on
page 139.
9. Connect the card reader cable to a USB 2.0 connector on the system board. See "Parts on the
system board" on page 34.
10. Reinstall the front bezel. See "Front bezel" on page 97.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 174.

Device in the 5.25-inch flex module

Attention: Before you replace any FRU, be sure to read and understand Chapter 1 "Read this first: Important
safety information" on page 1.
A 5.25-inch flex module might be equipped with some or all of the following components:
• Slim optical drive
• eSATA connector
• IEEE 1394 connector
• Card reader
• Front Thunderbolt adapter kit
• Seven-segment display
Installing or replacing a device in the 5.25-inch flex module involves the following operations:
• "Slim optical drive" on page 142
• "eSATA connector or IEEE 1394 connector" on page 144
• "Card reader" on page 147
• "Front Thunderbolt adapter kit" on page 150
.
Chapter 9 Installing or replacing hardware
141