Switching Between Audio-Only And Video Calls; Adjusting The Screen Layout - Huawei 9000 VCT V100R011 Administrator's Manual

HUAWEI 9000 HD Video Terminal
Administrator Guide

7.5 Switching Between Audio-only and Video Calls

To switch a call between audio-only and video modes, select
Prerequisites
The terminal is in a SIP point-to-point conference.
Context
You cannot switch modes in a call between audio-only and video if:
l
l
Procedure
Step 1 Select
Step 2 From the Video screen:
l
l
----End
Follow-up Procedure
To exit the Video screen, press
When Video request handling is set to Manual on the terminal, you can manually accept or
reject a video request from a remote site. If you do not acknowledge the request within 20
seconds, the request dialog box automatically closes.

7.6 Adjusting the Screen Layout

The screen layout can be adjusted using two methods. Press
between layouts. Alternatively, select Layout from the option bar to display a screen from which
a desired layout can be selected.
The HD OUT 1 and SD OUT 1 video output interfaces support the combined picture function.
To adjust the screen layout, choose either of the following methods:
Issue 09 (2012-09-03)
The terminal is in a cascaded conference.
The terminal is in a multipoint conference hosted by its built-in MCU.
on the option bar, and press
During an audio-only call: Select Turn On Video, and press
During a video call:
– Select Turn Off Video, and press
to an audio-only call.
– Click Hold, and press
NOTE
To display local video at the remote site again, click Cancel Hold.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
to display the Video screen.
to turn off both local and remote video and switch
to hide local video at the remote site.
.
7 Video and Audio
from the option bar.
to send a video request.
on the remote control to switch
124