Installing The Battery To Gt2310 Or Gt2308 - Mitsubishi Electric GOT2000 Series User Manual

Step 4.
Attach the environmental protection back cover and tighten the screws within the specified torque range
(0.36 N•m to 0.48 N•m).
Step 5.
Turn on the GOT.
Step 6.
Check that the battery condition is normal with the utility.
For the details of the battery condition display, refer to the following.
➠
6.10.5

Installing the battery to GT2310 or GT2308

The following shows the battery installation procedure, taking GT2310 as an example.
Step 1.
Make sure that the GOT power is off.
Step 2.
Install the battery to the GOT rear face.
Open the battery cover as shown below.
Step 3.
To replace the battery, remove the old battery, and then disconnect the connector.
For information on how to remove the battery, refer to the following.
➠
6 - 58
6.10 Installing the Battery
GOT2000 Series User's Manual (Utility)
6.11 Removing the Battery
Environmental
protection
back cover
screw
Battery cover