Mitsubishi Electric GOT2000 Series User Manual page 124

■2. Part names and settings of GT25HS-V
No.
1) Display section
2) Touch panel
3) Operation switch (6 switches)
Operation switch name sheet installation
4)
place
5) Emergency stop switch
6) POWER LED
Display LED for operation switch (6
7)
LEDs)
8) Display LED for grip switch
9) External interface connector
10) Environmental protection back cover
Environmental protection back cover
11)
screw
12) Hook for hanging on walls
13) Hand strap
14) Grip angle changing screw
15) Grip switch
16) Rating plate
17) Battery (inside the cover)
Connector for battery connection (inside
18)
the cover)
RS-422/485 ←→ RS-232 selection
19)
connector (inside the cover)
20) Terminating resistor setting switch
Emergency stop switch guard cover
21)
installing hole
22) Interface environmental protection cover
23) Keylock switch (2-position switch)
24) USB interface (Host)
25) USB interface (Device)
26) Reset switch
27) S.MODE switch (OS install switch)
28) SD card access switch
4 - 16
4.4 GT25HS-V
Name
Displays the utility screen and the user creation screen.
For touch switch operation on the utility screen and the user creation screen.
Switch for external direct wiring (independent contact)
Place (concave shape) where the operation switch name sheet (Insert into the space from a
transverse direction) is installed.
For the details, refer to the following.
➠
9.4.6 Operation switch name sheet creation
Switch for external direct wiring (independent contact)
Lit in blue
Lit in orange
Blinks in orange and blue: Backlight failure
Not lit
Display LED for operation switch (green) (lighting control from display section)
Display LED for grip switch (green) (lighting control from display section)
For external cable connection (for PLC, switch and power supply external wiring) (Connector
shape: square 42 pins, male)
Opened and closed when the PLC communication type is changed (RS-422/485 RS-232,
before shipping: RS-422/485), or the battery is replaced.
For opening and closing the environmental protection back cover (drop prevention screw)
Hook when the Handy GOT is used hanging on walls.
Used to hold the Handy GOT in hand by putting a hand under the strap.
Length adjustable.
Used when changing the angle of the grip. (5, M4 screw)
The angle of the grip can be set either to the standard angle (as before shipping) or 15
degrees to the right.
Switch for external direct wiring (independent contact)
-
GT15-BAT battery: For backup of clock data, system log data, and buffering data
For battery connection
RS-422/485 ←→ RS-232 selection connector
For switching the RS-422/485 communication interface terminating resistor (Set to Disable
before shipping)
Threaded hole for mounting the GT16H-60ESCOV type emergency stop switch guard (option)
Opened and closed when using the USB port, S.MODE switch and reset switch, as well as
when inserting the SD card.
Switch for external direct wiring (independent contact)
For data transfer, data storage (connector type: USB-A)
For PC connection (connector type: USB Mini-B)
Switch for resetting the hardware
Switch used for OS installation at GOT startup.
Enables or disables the access to the SD card when installing/removing the Handy GOT to/
from the GOT.
ON: SD card access allowed (The SD card cannot be removed.)
OFF: SD card access prohibited (The SD card can be removed.)
Description
: Power is properly supplied.
: Screen saving
: Power is not supplied.
Terminating resistor setting
switch enlarged view
ON side
ON
Terminating
Enable
1 2
Disable
OFF side
Set to "Disable" before shipping
Switch No.
resistor
1 2
ON ON
OFF OFF