Step 3.
Tighten nuts on the studs in the specified torque range (0.8 N•m to 0.9 N•m) with a wrench for M4 nuts.
Loosen the screws in the slotted holes of the fittings, and adjust the positons of the screws to make the GOT
display section and the control panel surface be in the same plane.
To attach the environmental protection sheet (sold separately), proceed to step 4.
To attach a user-prepared environmental protection sheet, follow the maunal of the sheet used.
Step 4.
Remove the inner part of the supplied stencil.
Position the stencil on the panel opening, and attach the stencil using backside double-sided tape in four
places.
Check that the arrow on the stencil points in the direction as shown below.
For the horizontally-oriented GOT, the arrow on the stencil must point upward.
•
For the vertically-oriented GOT, the arrow on the stencil must point leftward.
•
6 - 34
6.6 Installing the GOT
Stencil
Stud
Nut
Slotted hole
panel
Double-sided tape
Double-sided tape
Double-sided tape
on the
on the
on the
back of the stencil
back of the stencil
back of the stencil
GOT
panel opening