Gt25Hs-V - Mitsubishi Electric GOT2000 Series User Manual

3.1.2

GT25HS-V

Item
Operating ambient temperature
Storage ambient temperature
Operating ambient humidity
Storage ambient humidity
Vibration resistance
Shock resistance
Operating atmosphere
*1
Operating altitude
*2
Overvoltage category
*3
Pollution degree
Cooling method
Grounding
*1 Do not use or store the GOT under a pressure higher than the atmospheric pressure at altitude 0 m.
Doing so may cause a malfunction.
*2 This indicates the section of the power supply to which the equipment is assumed to be connected between the public electrical
power distribution network and the machinery within the premises.
Category II applies to equipment that is supplied with power from fixed facilities.
The withstand surge voltage for the equipment with the rated voltage up to 300 V is 2500 V.
*3 This indicates the occurrence rate of conductive material in an environment where a device is used.
Pollution degree 2 indicates an environment where only non-conductive pollution occurs normally and a temporary conductivity
caused by condensation shall be expected depending on the conditions.
Under
Compliant with intermittent
JIS B 3502 and vibration
IEC 61131-2
Under
continuous
vibration
Compliant with JIS B 3502 and IEC 61131-2 (147 m/s
No greasy fumes, corrosive gas, flammable gas, excessive conductive dust,
Grounding with a ground resistance of 100 Ω or less by using a ground cable that has a cross-sectional area of
If impossible, connect the ground cable to the control panel.
Specifications
0 °C to 40 °C
-20 °C to 60 °C
10% RH to 90% RH, non-condensing
10% RH to 90% RH, non-condensing
Frequency Acceleration
5 to 8.4 Hz -
2
8.4 to 150 Hz
9.8 m/s
5 to 8.4Hz -
2
8.4 to 150 Hz
4.9 m/s
2
(15G), 3 times in each X, Y, or Z direction)
and direct sunlight (as well as at storage)
2000 m or less
II or less
2 or less
Self-cooling
2
2 mm or more.
3.1 General Specifications
Half amplitude Sweep count
3.5 mm 10 times in each
X, Y, or Z
-
direction
1.75 mm
-
-
3 - 3
3