Remote Transmitter Terminal Housing - Probe Cable Connections - ABB Endura AZ30 series Programming Manual

Endura AZ30 series integral probe and remote transmitter
Combustion oxygen monitor
5.3.3 Remote Transmitter Terminal Housing – Probe Cable Connections
Caution.

Before making probe cable connections, refer to Probe User Guide OI/AZ30P–EN for probe cable
preparation and Section 4.8, page 17 for M25 (or

Connections from the transmitter to the remote transmitter terminal housing are made at the
factory – ensure they are not disturbed when connecting probe wires.

For non-ABB supplied probe cable, refer to Probe User Guide OI/AZ30P–EN for cable
requirements.
Referring to Fig. 5.5:
1. Unscrew and remove the remote transmitter terminal housing lid
flats if necessary).
2. Trim cable to length according to requirements.
3. Loosen cable gland
C
housing .
Probe Cable Heater
Connections
(behind remote
transmitter terminal
housing lid)
 265 V AC
Fig. 5.4 Access to Terminals – Remote Transmitter Terminal Housing
24
B
and feed the (prepared) probe cable through the remote transmitter terminal
A
3
/ in.) barrier gland requirements.
4
A
(a lever can be used across the
5 Electrical Installation
Hazardous
B
Area Gland
C
COI/AZ30E–EN Rev. D