ABB Endura AZ30 series Programming Manual page 46

Endura AZ30 series integral probe and remote transmitter
Combustion oxygen monitor
Parameter
...Calibrate
...Scheduled Cal.
Daily Interval
Daily
2, 3, 4, 5, 6, 7 Days
Weekly Interval
Weekly
2, 3, 4, 6, 13,
26, 52 Weeks
Monthly Interval
Monthly
2, 3, 4, 6, 12 Months
Table 6.7 Calibrate Menu (Continued)
44
Comment / [Range]
If AutoCal is fitted, calibrations can be set to run
automatically at scheduled time intervals.
Note. This option is not available if the AutoCal
Hardware / Hardware Type is set to None.
Sets the required daily interval for scheduled automatic
calibrations of the probe.
Enabled when Frequency is set to Daily
Sets the required weekly interval for scheduled
automatic calibrations of the probe.
Enabled when Frequency is set to Weekly
Sets the required monthly interval for scheduled
automatic calibrations of the probe.
Enabled when Frequency is set to Monthly
6 Programming
Default
Daily
Weekly
Monthly
COI/AZ30E–EN Rev. D