Device Setup - ABB Endura AZ30 series Programming Manual

Endura AZ30 series integral probe and remote transmitter
Combustion oxygen monitor

6.4.4 Device Setup

Menu
Device Setup
Exit
Parameter
Instrument Tag
Probe Type
AZ20 & Integral Tx
AZ20 & Remote Tx
AZ25 & Remote Tx
AZ30 & Integral Tx
AZ30 & Remote Tx
AZ35 & Remote Tx
Cable Length
Table 6.9 Device Setup Menu
COI/AZ30E–EN Rev. D
Used by Advanced users to set the instrument tag, specify the
4
type of probe, select cable length, set oxygen and
temperature ranges and to setup passwords for access at all
levels.
Standard users have read-only privileges (except at the
Security Setup level) and Read Only users have read-only
Select
privileges for a reduced set of menu options.
Comment / [Range]
Used to enter a tag (ID) of up to 20 characters in length for
the transmitter.
Characters are selected from an alphanumeric list.
The 'Instrument Tag' is not displayed in the Operator
page(s) when a Display Mode of 3 x 9 is selected – see
Section 6.4.5, page 52.
Selects the probe type to be used with the transmitter.
The length in metres of the cable between the probe and
the remote transmitter. This length is used in the cold
junction measurement to compensate for the impedance
of the cable.
[0 to 100 m]
Note. Applicable only to remote transmitters.
6 Programming
Default
N / A
Factory-set
0 m
49