About Programming
Illustration 5.8 Wiring Example for External Device Providing
0–10 V Control Signal (Frequency Converter Left, External
5
5
Device Right)
5.3 Control Terminal Programming
Examples
Control terminals can be programmed.
•
Each terminal has specified functions it is capable
of performing
•
Parameters associated with the terminal enable
the function
See Table 2.5 for control terminal parameter number and
default setting. (Default setting can change based on the
selection in parameter K-03 Regional Settings.)
The following example shows accessing Terminal 18 to see
the default setting.
1.
Press [Main Menu] twice, scroll to Parameter Data
Set and press [OK].
Illustration 5.9 Parameter AN-15 Terminal 53 High Ref./Feedb.
Value
2.
Scroll to parameter group E-## Digital In/Out and
press [OK].
40
Illustration 5.10 Digital In/Out
3.
Scroll to parameter group E-0# Digital Inputs and
press [OK]
4.
Scroll to parameter E-01 Terminal 18 Digital Input.
Press [OK] to access function options. The default
setting Start is shown.
Illustration 5.11 Digital Inputs
5.4 International/North American Default
Parameter Settings
Setting parameter K-03 Regional Settings to [0] International
or [1] North America changes the default settings for some
parameters. Table 5.1 lists those parameters that are
effected.
Parameter
Parameter K-03 Regi
onal Settings
Parameter P-07 Mot
or Power [kW]
Parameter P-02 Mot
or Power [HP]
Parameter F-05 Mot
or Rated Voltage
DET-767c All rights reserved.
International default
North American
parameter value
default parameter
value
International
North America
See Note 1
See Note 1
See Note 2
See Note 2
230 V/400 V/575 V
208 V/460 V/575 V
MG35M402