GE AF-650 GP Design And Installation Manual page 54

Application Set-Up Examples
CAUTION
Thermistors must use reinforced or double insulation to
meet PELV insulation requirements.
Table 6.10 Motor Thermistor
MG35M402
AF-650 GP™ Design and Installation Guide
Parameters
Function Setting
Parameter F-10 El [2]
ectronic Overload Thermistor
trip
Parameter F-12 M [1] Analog
otor Thermistor input 53
Input
* = Default Value
Notes/comments:
If only a warning is desired,
parameter F-10 Electronic
Overload should be set to [1]
Thermistor warning.
DET-767c All rights reserved.
Table 6.11 Mechanical Brake Control
Illustration 6.4 Illustration for Table 6.11
In the upper right corner of the keypad, 2 numbers are
shown – like 1(1). The number outside the parenthesis is
the active set-up and the number inside the parenthesis is
the set-up which is edited. Default is always 1(1). Make
sure that you edit set-up 1.
Parameters
Function Setting
Parameter E-24 F [32] Mech.
unction Relay brake ctrl.
Parameter E-01 T [8] Start*
erminal 18
Digital Input
Parameter E-02 T [11] Start
erminal 19 reversing
Digital Input
Parameter F-24 H 0.2
olding Time
Parameter F-25 St [5] Advanced
art Function Vector
Control/FLUX
Clockwise
Parameter F-29 St Im,n
art Current
Parameter B-20 R Application
elease Brake dependent
Current
Parameter B-21 A Half of
ctivate Brake nominal slip
Speed [RPM] of the motor
* = Default Value
Notes/comments:
51
6 6