System Start-Up - GE AF-650 GP Design And Installation Manual

Start-up and Functional Tes...

3.7 System Start-up

The procedure in this section requires user-wiring and
application programming to be completed.
chapter 6 Application Set-Up Examples is intended to help
with this task. Other aids to application set-up are listed in
chapter 1.3 Additional Resources. The following procedure is
recommended after application set-up by the user is
completed.
CAUTION
MOTOR START
Ensure that the motor, system, and any attached
equipment are ready for start. It is the responsibility of
the user to ensure safe operation under any condition.
Failure to do so could result in personal injury or
equipment damage.
1. Press [Auto].
2. Ensure that the external control functions are
properly wired to the frequency converter and all
programming is completed.
3. Apply an external run command.
4. Adjust the speed reference throughout the speed
range.
5. Remove the external run command.
6. Note any problems.
If warnings or alarms occur, see chapter 10 Warnings and
Alarms for resetting the frequency converter after a trip.
MG35M402
AF-650 GP™ Design and Installation Guide
DET-767c All rights reserved.
3 3
33