Pc No - Mitsubishi Electric MELSEC IQ-R series Reference Manual

PC No.

Specify the station No. of the access target.
Accessing the connected station (host station)
Specify 'FF'.
External device
Accessing other stations via network
Specify the network module station No.01H to 40H (1 to 64) of the access target.
External device
Setting method
■Data communication in ASCII code
Convert the numerical value to 2-digit ASCII code (hexadecimal), and send it from the upper digits.
■Data communication in binary code
Send a 1-byte numerical value.
Ex.
Accessing the connected station (host station)
ASCII code
F F
46 46
H H
When accessing other station of network station No. '3'.
ASCII code
0 3
30 33
H H
The station No. of the network module can be checked by using the following parameters of Engineering tool.
• GX Developer and GX Works2: "Network Parameter"
• GX Works3: "Module Parameter"
The network module station No. is set in decimal. However, the PC No. is set in hexadecimal.
When specifying the network of the access target is required, set "Valid Module During Other Station Access"
with an Engineering tool.
Connected station
:Access target station
(Host station)
Connected station
(host station)
Network
Binary code
FF
H
Binary code
03
H
Other station
:Access target station
18 COMMUNICATING USING 1E FRAMES
18.2 Details of Setting Data
18
393