Register Data (Command: 1610) - Mitsubishi Electric MELSEC IQ-R series Reference Manual

Register data (command: 1610)

Register user frames to C24.
For MELSEC iQ-R series, the user frame is replaced with the contents registered using module extended
parameters by powering OFF  ON or switching the CPU module STOP  RUN. For more information on
user frame registration using module extended parameters, refer to the following manual.
 MELSEC iQ-R Serial Communication Module User's Manual (Application)
When registering a user frame with the same frame No. again, deleted the user frame first and registered
again. If it is attempted to register a user frame by specifying an already registered frame No., an error occurs
and an abnormal response is returned.
Message format
The following shows the message format of the request data and response data of the command.
■Request data
Command Subcommand
■Response data
There is no response data for this command.
Data specified by request data
■Command
ASCII code
1 6 1 0
31 36 31 30
H H H H
*1 For C24, an additional code is added. (Page 35 Additional code (10H))
■Subcommand
ASCII code
0 0 0 0
30 30 30 30
H H H H
■Frame No.
Specify the number of user frame to be registered. (Page 247 Frame No.)
Type Setting value
User frame 3E8H to 4AFH
8001H to 801FH
■Number of registration data byte, number of frame byte
Specify the byte count of registration data within the range of 1 to 80. (Page 247 Number of registration data byte, number
of frame byte)
■Registration data
Store the content of user frame data to be registered. (Page 248 Registration data)
Number of
Frame No.
registration
data byte
*1
Binary code
DLE
10 10 16
H H H
Binary code
00 00
H H
Registration destination
Flash ROM of C24
Buffer memory of C24 (addresses 1B00H to 1FF6H)
13 SERIAL COMMUNICATION MODULE DEDICATED COMMANDS
Number of
Registration data
frame byte
13
251
13.1 User Frame