Input/Outputs - GE Multilin F650 Instruction Manual

4 HUMAN INTERFACES

4.1.7.5 INPUT/OUTPUTS

Section that contains the settings for all input and output boards and the Force Outputs and Virtual inputs activation tools.
Table 4–12: GENERAL OVERVIEW OF "INPUTS/OUTPUTS" SETTINGS MENU.
INPUTS/
OUTPUTS
Contact I/O
Force Outputs (*)
Virtual Inputs (*)
Remote Comms.
Options enabled only in On-line mode are marked as (*). Options enabled only in Off-line mode are marked as (**)
This section shows the settings related to inputs and outputs for the different boards available in F650 (F, G, H, J).
Table 4–13: GENERAL OVERVIEW OF "INPUTS/OUTPUTS>CONTACT I/O" SETTINGS MENU.
CONTACT I/O
Board F
Board G
Board H
Board J
GE Multilin
4.1 ENERVISTA 650 SETUP SOFTWARE INTERFACE
Inputs and outputs settings for all boards in F650. The I/O settings
configuration can only be performed through EnerVista 650 Setup, not
HMI available.
This menu allows activating each contact output in the relay, to facilitate
maintenance testing. On line mode only.
This menu allows operating virtual inputs. These variables are used as
inputs to logic schemes configured in the relay. Virtual inputs can be
operated in a latched mode (32 latched virtual inputs) or in Self-reset
mode (32 self reset virtual inputs).
This menu allows configuring remote inputs coming from other devices
through GSSE messages.
Board located in first slot, always connected, either type 1 or 2.
Board located in second slot, depends on model definition. If model is
type G0 there is no board in second slot.
Board located in first slot of CIO Module (external inputs/outputs module)
Board located in second slot of CIO Module (external inputs/outputs
module)
F650 Digital Bay Controller
4
4-23