ABB 800xA Operation page 130

HXAM_G_Faceplate
Figure 62. Mass FlowTab
130
Enabled:
Not Enabled:
Stale Data in Trained Set: If one or more BOPS is stale.
Not Available:
Data Unavailable:
– Limit Reached: Gives the subcondition for the W_Hot_Operating_Point
condition. The different subconditions that will be reported during
Monitoring are:
Normal:
Increasing:
Section 9 Heat Exchanger Asset Monitor (HXAM)
TC08483A
If Mass Flow Hot Monitor is enabled.
If Mass Flow Hot Monitor is not
enabled.
During Training.
If Mass Flow Hot Monitor is enabled,
but Mass Flow Hot is not available.
Mass Flow Hot is within the Normal
range.
Mass Flow Hot has crossed the
W_ Hot _Increasing Limit.
3BUA000150-600