Canon ImageRUNNER 2545i Sending And Facsimile Manual page 53

[Pause]:
[Tone]:
2 [R]:
[ ] [ ]:
[Backspace]:
IMPORTANT
You cannot insert a pause at the beginning of a number.
NOTE
• For instructions on how to enter characters, see Chapter 2, "Basic Operations," in the
Reference Guide.
• The pause time differs in length, depending on whether it is entered in the middle or at
the end of a fax number.
- The pause time entered in the middle of a fax number (lower-case p) is set to four
- The pause time entered at the end of a fax number (upper-case P) is set to 10
• Two or more pauses can be entered consecutively.
• You can press
4
● If you want to check or change the specified destination:
❑
2-26
Basic Sending Methods
Press to insert a pause of several seconds in the fax number you
are dialing. If you insert a pause within the fax number, the letter
<p> is displayed between the numbers. If you insert a pause at
the end of the fax number, the letter <P> appears. When dialing
an overseas number, insert a pause after the international
access code and at the end of the fax number. (See "Dialing an
Overseas Number," on p. 2-52.)
Press when you want to directly call an extension line that is
connected to a PBX (Private Branch eXchange), which accepts
only tone dialing. If you press [Tone], the letter <T> appears.
Press to use the R-key. (See "Calling from an Extension," on
p. 2-50.)
Press to move the position of the cursor.
Press to delete the number immediately to the left of the cursor.
seconds long by default. This can be changed to any length between 1 and 15
seconds. (See "Adjusting the Pause Time," on p. 7-25.)
seconds long. (This length cannot be changed.)
(Clear) to clear your entry.
Press [Details] ➞ check or change the destination's information ➞ press [OK].
For help, see step 4 in "Sending an E-Mail Message," on p. 2-2.
Press [OK].
The specified destination appears on the
top screen.