Error Codes - Canon ImageRUNNER 2545i Sending And Facsimile Manual

Remedy 2 Make sure that an e-mail address attribute is registered on an authentication
Cause 2
Remedy

Error Codes

If your sending and receiving jobs are unsuccessful, check for error codes to
identify the problem. Error codes can be found in the log of the System Monitor
screen or are printed on the communication reports. (See Chapter 8, "Printing
Communication Reports and Lists.")
# 0001
Cause
Remedy
# 0003
Cause
9
Remedy 1 Reduce the resolution or divide the document into two or more parts, and then
Remedy 2 When receiving a document, ask the sender to either reduce the resolution at
# 0005
Cause 1
Remedy
Cause 2
Remedy
9-12
Self-diagnostic Display
server.
You tried to send e-mails or I-faxes when the machine is in the User ID
Management with the e-mail address of the login user not registered.
Register the e-mail address for each user when User ID Management is
enabled. (See Chapter 3, "Specifying Department ID and User Management," in
the Remote UI Guide.)
Paper or originals are jammed.
Remove any jammed paper or originals. (See Chapter 6, "Troubleshooting," in
the Reference Guide.)
Communications that take longer than the preset time (64 minutes) caused the
error.
try sending it again. (See "Specifying the Color Mode and Resolution," on
p. 3-2.)
which the document is scanned or divide the document into two or more parts
before sending it.
The recipient did not answer within 35 seconds.
Confirm that the recipient's machine is able to communicate, and try again.
The recipient's machine is not a G3 fax.
Check the type of receiving machine with the receiving party.