Canon ImageRUNNER 2545i Sending And Facsimile Manual page 291

# 0408
Cause 1
Remedy
Cause 2
Remedy
# 0703
Cause
Remedy 1 Wait for a few moments and try again after other send jobs are complete.
Remedy 2 Delete documents stored in memory. If the machine still does not operate
# 0705
Cause
Remedy 1 Change the setting for <Maximum TX Data Size> in E-mail/I-Fax Settings. (See
9
Remedy 2 Select a lower resolution. (See "Specifying the Color Mode and Resolution," on
Remedy 3 If you are using I-fax, decrease the number of pages containing images that you
Remedy 4 Set Divide into Pages to 'On' on the File Format screen. (See "Specifying the
# 0751
Cause 1
Remedy
9-16
Self-diagnostic Display
The transfer of data has failed because the USB memory media device was
pulled out during the transfer.
Check that the USB memory media device is properly inserted, and then try the
transfer again.
An error occurred while data, such as image data, was being transferred to the
USB memory media device.
Check the status of the USB memory media device, or make sure that the
device is formatted with a file system supported by the machine (FAT16 or
FAT32), and then try again.
The memory for image data is full when sending color documents.
normally, turn the main power OFF and then back ON.
The send operation was interrupted because the size of the image data is larger
than that specified in <Maximum TX Data Size> in E-mail/I-Fax Settings.
Chapter 4, "Setting the Send Function," in the System Settings Guide.)
p. 3-2.)
are sending each time, so that you do not exceed the data size limit specified in
<Maximum TX Data Size>.
File Format," on p. 3-20.)
The file server is not functioning.
Check that the file server is operating properly.