Table of Contents
Advertisement
Setup
1
Installing the Valve Lever
Parts needed for this procedure:
1
Speed selector valve lever
Procedure
1. Remove and discard the nut securing the bolt and
lock washer to the speed selector lever.
2. Secure the lever to the speed selector valve using the
bolt and lock washer as illustrated in Figure 3.
1. Speed selector valve lever 2. Speed selector valve
2
Checking Fluid Levels
No Parts Required
Procedure
Before starting the engine for the first time, check the
engine oil, hydraulic fluid, and engine coolant levels.
Refer to Operation for more information.
Figure 3
3
Activating the Battery
No Parts Required
Procedure
The traction unit is shipped with a dry battery. You must
purchase bulk electrolyte with 1.260 specific gravity
from a local battery supply outlet.
Battery terminals or metal tools could short
against metal components, causing sparks.
Sparks can cause the battery gasses to explode,
resulting in personal injury.
• When removing or installing the battery, do
not allow the battery terminals to touch any
metal parts of the traction unit.
• Do not allow metal tools to short between
the battery terminals and metal parts of the
traction unit.
1. Park the traction unit on a level surface, raise the
loader arms, and install the cylinder locks.
2. Stop the engine and remove the key.
3. Remove the four bolts securing the battery cover
and remove the cover (Figure 4).
1. Battery cover
2. Bolt
3. Battery
4. Bars
4. Remove the nuts and bars securing the battery
(Figure 4).
11
Figure 4
5. Nut
6. Positive cable
7. Negative cable
Advertisement
Table of Contents
