Replacing A Fuse - Toro 25500 Operator's Manual

4. Connect the battery charger to the electrical source.
Important: Do not overcharge the battery.
Note: Charge the battery as shown in the following
table:
Battery Charging Settings and Times
Charger Setting
4 to 6 amperes
25 to 30 amperes
5. When the battery is fully charged, unplug the charger
from the electrical source, then disconnect the charger
leads from the battery posts

Replacing a Fuse

1. Remove the left and right side panel; refer to
the Side Panels (page
2. Rotate the battery-disconnect switch counterclockwise
to the Off position
Figure 79
1. Battery-disconnect switch
in the On position
3. Remove the 4 hex-flanged bolts (5/16 x 3/4 inch) that
secure the cover to the console and remove the cover
(Figure 80).
Charging Time
30 minutes
10 to 15 minutes
(Figure 78).
Removing
44).
(Figure 79).
2. Battery-disconnect switch
in the Off position
1. Hex-flanged bolts (5/16 x
3/4 inch)
2. Cover
3. Console
4. Locate the open fuse and replace it with a fuse of the
same type and amperage
5. Check that the new electrical components function.
6. Align the hole in the cover with the nut clips on the
flanges of the console
7. Secure the cover to the console with the 4 hex-flanged
bolts that you removed in step 3.
8. Rotate the battery-disconnect switch clockwise to the
On position (Figure
9. Install the left and right side panel; refer to
the Side Panels (page
54
Figure 80
4. Fuse block
5. Fuses
(Figure 80).
(Figure 80).
79).
Installing
45).