Toro 25500 Operator's Manual page 23

Note: Remove the cap slowly to reduce the air
pressure buildup.
2. Fill the fuel tank to the bottom of the neck to allow
space for the fuel to expand.
Note: The fuel tank capacity is 182 L (48 US gal).
3. Install the fuel-tank cap and tighten it securely by hand.
Draining Water from the Fuel-Water
Separator
Service Interval: Before each use or daily
1. Remove the left side panel; refer to
Panels (page 44).
2. Place a drain container below the drain valve on the
fuel-water separator
1. Fuel-water separator
3. Rotate the drain valve counterclockwise approximately
3-1/2 turns until the valve drops down from the
fuel-water separator
Note: The valve should extend 25 mm (1 inch) from
the separator.
Removing the Side
(Figure 21).
Figure 21
2. Drain valve
(Figure 22).
1. Open the drain valve.
2. Drain the water.
4. Drain the water and sediment from the separator until
clear fuel is visible
5. Lift up the valve and turn it clockwise until it is hand
tight (Figure 22).
Note: Do not overtighten the drain valve of the
fuel-water separator; overtightening the valve can
damage the threads of the valve.
6. Install the left side panel; refer to
Panels (page 45).
23
Figure 22
3. Close the drain valve.
(Figure 22).
Installing the Side