Table of Contents
Advertisement
Key Switch
Use the key switch to power the electrical accessories, start the
machine, and stop the machine
positions are as follows:
•
Accessory—Rotate the key switch to this position to
energize the lamp switch circuits.
•
Stop—Rotate the key switch to this position to stop the
engine and de-energize the electrical system.
Note: Always remove the key before leaving the
machine.
•
Run—This position allows the engine to run and will
energize all electrical systems.
•
Start—Rotate the key switch to this position to start the
engine.
Note: When you release the key, it will automatically go
to the Run position.
Foot Pedal
The foot pedal controls the direction and speed of travel of
the machine
(Figure
13).
1. Heel pedal (reverse)
Traction-Control Cluster
The traction-control cluster is located at the operator seat,
adjacent to the left armrest.
Utility-Traction Joystick
When trenching, plowing, or boring, use the utility-traction
joystick to change the direction and speed of the machine
(Figure
14). The further you move the joystick in either
direction, the faster the machine will move in the selected
direction.
(Figure
11). The 4 key-switch
Figure 13
2. Toe pedal (forward)
•
Move the utility-traction joystick forward to move the
machine forward
(Figure
•
Move the traction joystick rearward to move the machine
in reverse
(Figure
•
Move the traction joystick to the center (Neutral) position
to stop the machine
1. Traction-control cluster
2. Gear-selector switch
Note: The engine speed is controlled with the throttle
buttons on the home screen of the command-center panel;
refer to
Throttle Button (page
Gear-Selector Switch
The gear-selector switch is located on top of the utility-traction
joystick
(Figure
14), and is used to select the transmission gear.
The current gear is displayed on the home screen of the
command center, above and to the left of the tachometer
display.
Attachment-Control Cluster
The attachment-control cluster is located at the operator seat
and is adjacent to the right armrest.
Backfill-Blade / Vibratory-Plow Joystick
Note: The backfill blade and the vibratory plow are optional
attachments.
Note: The function of the backfill blade / vibratory plow
joystick depends on the attachment selected in the command
center.
The backfill-blade/vibratory-plow joystick operates either
the backfill blade or the vibratory plow, whichever is selected
and displayed on the command center. Move the joystick
controls to change the backfill blade or the vibratory plow
position as follows:
17
14).
14).
(Figure
14).
Figure 14
3. Utility-traction joystick
16).
Advertisement
Table of Contents
