Table of Contents
Advertisement
Welding on the Machine
Important: Before you use an electric welder to repair
or modify the machine, perform all the following:
•
Rotate the battery-disconnect switch to the Off position
•
Disconnect the negative and positive battery cables.
•
Disconnect the wiring at the alternator.
•
Disconnect the 2 connectors for the computer module.
•
Disconnect the connector for the command-center
display.
After you complete welding on the machine, connect the
command–center display, computer module, alternator, and
battery cables and rotate the .battery-disconnect switch to
the On position
Preparing to Disconnect the
Components
1. Remove the right side panel; refer to
Side Panels (page
44).
2. Rotate the battery-disconnect switch to the Off
position; refer to
Battery-Disconnect Switch (page
3. Remove the 2 finger-pull covers from the holes in the
battery cover
(Figure
Note: The battery cover is located between the
operator seat and the rear ROPS bulkhead.
Figure 114
1. Operator seat
2. Finger-pull cover
3. Hole (battery cover)
4. Remove the 4 flange-head bolts (5/16 x 1 inch) that
secure the battery cover to the ROPS platform
114).
Removing the
114).
4. Flange-head bolts (5/16 x
1 inch)
5. Nut clip
6. ROPS bulkhead
5. Using the finger pulls, lift the battery cover up to
remove it from the ROPS platform
6. Remove the lock-washer nut (3/8 inch) securing the
negative-battery cable and ring terminal to the negative
stud of the battery and remove the cables from the
battery
20).
1. Positive-battery cable
2. Negative-battery cable
3. Ring terminal
7. Move back the insulator boot and remove the
lock-washer nut (3/8 inch) securing the positive-battery
cable to the positive stud of the battery and remove the
cable from the battery
(Figure
73
(Figure
115).
Figure 115
4. Lock-washer nut (3/8 inch)
5. Negative stud (battery)
6. Positive stud (battery)
(Figure
115).
(Figure
114).
Advertisement
Table of Contents
