Specifications; Attachments/Accessories - Toro 25500 Operator's Manual

Seat-Rotation Lever and Seat-Weight Compensator
•
Seat-rotation lever—Use this lever to unlock the seat
so that you can rotate the seat to the desired position.
The seat will rotate 360° and lock into position at 10°
increments (Figure 17).
Note: Rotate the seat to the Front position before
driving the machine.
•
Seat-weight compensator—Rotate this lever for the
weight compensator to adjust the seat support tension for
the weight of the operator
– Rotate the lever for the weight compensator clockwise
to increase the support tension of the seat.
– Rotate the lever for the weight compensator
counterclockwise to reduce the support tension of
the seat.
Armrest-Height Control
Rotate the armrest-height control to raise or lower the
armrest (Figure 17).
Seat-Lumbar Knob
Rotate the seat-lumbar knob, found behind the seat, to adjust
the back lumbar support for best comfort
Seat Belt
WARNING
Operating the machine without the rollover
protection system (ROPS) securely in place can
result in serious injury or death if the machine rolls
over.
• Ensure that the roll bar is securely in place.
• Always wear a seat belt with the ROPS in place.
• Ensure that the operator seat is properly secured
to the machine.
Note: Regulations in some localities require that seat belts on
construction machines be 76 mm (3 inch) wide. Check with
local authorities regarding the requirements for seat belts.
•
To fasten the seat belt, insert the tab end into the left
buckle.
Note: Ensure that the tab end and the buckle are
securely fastened.
•
To release the seat belt, push the button on the buckle.
Battery-Disconnect Switch
The battery-disconnect switch is located behind the right
engine cowl (Figure 18); use it to electrically disconnect the
battery from the machine.
(Figure 17).
(Figure 17).
1. Battery On position
•
Rotate the battery disconnect clockwise to the On
position.
•
Rotate the battery disconnect counterclockwise to the
Off position.

Specifications

Note: Specifications and design are subject to change
without notice.
Machine Dimensions and Weight Data
Wheel base
Overall height (to the top of
the ROPS)
Overall width (at the tires)
Minimum ground clearance
Turning radius (2-wheel
steering)
Turning radius (4-wheel
steering)
Weight (without attachments)

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
20
Figure 18
2. Battery Off position
195 cm (76.8 inches)
281 cm (110 inches)
218 cm (85.8 inches)
28.5 cm (11.2 inches)
115 cm ( 291 inches)
391 cm (154 inches)
4,343 kg (9,575 lb)