Adding Rear Ballast; Installing The Eu Decal; Product Overview; Controls - Toro 04384 Operator's Manual

(Figure 12, Figure 13, and Figure 14). Rotate the screw
outward to raise and inward to lower. Tighten the jam
nut after the proper height is obtained.
8. Rotate the transport plate until it locks the pull frame.
Tighten the screws.
11

Adding Rear Ballast

Parts needed for this procedure:
Rear weight kit, Part No. 100-6442 (purchase
1
separately)
18 kg
Calcium chloride (purchase separately)
(40 lb)
Rear weight kit, Part No. 99-1645 (purchase
1
separately)
Procedure
This unit complies with the ANSI B71.4-2004 and EN 836
Standards when it is equipped with a rear weight kit, part
no. 100-6442 and 18 kg (40 lb). of calcium chloride ballast
is added to the rear wheel. If a 3 Wheel Drive kit is installed
on the machine, use rear weight kit, part no. 99-1645 instead,
and 18 kg (40 lb.) of calcium chloride.
Important: If a puncture occurs in a tire with calcium
chloride, remove the unit from the turf area as quickly
as possible. To prevent possible damage to the turf,
immediately soak the affected area with water.
12

Installing the EU Decal

Parts needed for this procedure:
1 Warning decal 121-2641
Procedure
If using this machine in the EU, affix the warning decal
121-2641 over English warning decal 121-2640.

Product Overview

Controls

Traction and Stopping Pedal
The traction pedal (Figure 15) has three functions: to make
the machine move forward, to move it backward, and to stop
the machine. Press the top of the pedal to move forward
and the bottom of the pedal to move backward or to assist
in stopping when moving forward. Also, allow the pedal
to move to the neutral position to stop the machine. For
operator comfort, do not rest the heel of your foot on reverse
when operating forward (Figure 16).
1. Traction pedal
2. Brake pedal
Brake Pedal
The brake pedal (Figure 15) actuates an automotive drum-type
mechanical brake at each traction wheel.
Parking Brake Lever
Pressing the brake pedal to actuate the brake assembly, then
pressing the small lever indicated (Figure 15) will keep the
19
Figure 15
3. Parking brake lever
Figure 16