Adding Rear Ballast; Install Decal; Reading The Manuals And Viewing The Training Materials - Toro 04356 Operator's Manual

Leave approximately 1/2 inch (13 mm) of threads
exposed on each mounting bolt (Figure 11).
1. Bolts
8. Remove the protective covers from the cutting units
and the reel drive motor shafts.
Note: Retain the protective covers for the cutting
units. Install them whenever the reel drive motors
are removed to protect the cutting unit bearings
from contamination.
9. Using a hand pump grease gun, fill the cavity at the
end of the cutting unit with #2 general purpose
grease.
10. Coat the spline shaft of the motor with clean grease
and install the motor by rotating the motor clockwise
so that the motor flanges clear the studs. Rotate
the motor counterclockwise until the flanges are
encircling the studs.
11. Tighten the mounting bolts (Figure 11).
6

Adding Rear Ballast

Parts needed for this procedure:
40 lb. Calcium chloride (purchase separately)
Procedure
This unit complies with the ANSI B71.4-2004 Standard
when 40 lb of calcium chloride ballast is added to the
rear wheel.
Important: If a puncture occurs in a tire with
calcium chloride, remove the unit from the turf area
as quickly as possible. To prevent possible damage
Figure 11
2. Drive motor
to the turf, immediately soak the affected area with
water.
7

Install Decal

Parts needed for this procedure:
1 Warning decal
Procedure
Affix the warning decal (93–8063) over the warning
decal (104–2053) for CE
8
Reading the Manuals and
Viewing the Training Materials
Parts needed for this procedure:
1 Operator's Manual
1 Engine Operator's Manual
1 Parts Catalog
1 Operator Training Materials
1 Pre-delivery Inspection Sheet
1
Noise rating certificate
1 Certificate of compliance
2 Ignition keys
Procedure
1. Read the manuals.
2. View the Operator training materials.
3. Store the documentation in a safe place.
15