Adjusting The Transport Speed; Adjusting The Mowing Speed - Toro 04384 Operator's Manual

E. From each side of the bulkhead, tighten the
locknuts evenly, securing the traction cable to the
bulkhead (Figure 42). Do not twist the cable.
Note: If cable tension exists when the functional
control lever is in neutral, the machine may creep
when the lever is moved to the Mow or Transport
position.
Note: If the wheel still turns when the eccentric
is at the maximum adjustment, contact your
Authorized Service Distributor or refer to the
Service Manual for further adjustment.

Adjusting the Transport Speed

The traction pedal is adjusted for maximum transport speed
at the factory, but an adjustment may be required if the pedal
reaches full stroke before it contacts the pedal stop, or if a
decrease in transport speed is desired.
Press down on the traction pedal. If the pedal contacts
the stop (Figure 43) before tension is felt on the cable, an
adjustment is required:
1. Pedal stop
1. Loosen flangehead locknuts securing the pedal stop to
the floor plate (Figure 43).
2. Adjust the pedal stop so it contacts the pedal rod and
tighten the nuts.

Adjusting the Mowing Speed

The machine is adjusted at the factory, but speed may be
varied if desired.
1. Loosen the jam nut on the trunnion bolt (Figure 44).
2. Loosen the nut securing the lock and mow brackets
on the pedal pivot.
Figure 43
1. Jam nut
2. Nut
3. Rotate the trunnion bolt clockwise to reduce the
mowing speed and counterclockwise to increase the
mowing speed.
4. Tighten the jam nut on the trunnion bolt and the nut
on the pedal pivot to lock the adjustment (Figure 44).
Check the adjustment and adjust as required.
38
Figure 44
3. Trunnion bolt