Adding Rear Ballast; Install Eu Decals; Reading The Manuals And Viewing The Training Materials - Toro 04383 Operator's Manual

holders in the machine frame. Damage to the
motors or hoses could result.
6. Ensure each carrier frame is at the same height from
the ground. If they are, proceed to step 8.
7. If the carrier frames are not at the same height, loosen
the jam nut on the carrier frame adjusting screw
(Figure 19, Figure 20 and Figure 21). Rotate the screw
outward to raise and inward to lower. Tighten the jam
nut after the proper height is obtained.
8. Rotate the transport plate until it locks the pull frame.
Tighten the screws.
10

Adding Rear Ballast

Parts needed for this procedure:
40 lb Calcium chloride (purchase separately)
Procedure
This unit complies with the ANSI B71.4-2004 and EN 836
Standards when 40 lb of calcium chloride ballast is added
to the rear wheel.
Important: If a puncture occurs in a tire with calcium
chloride, remove the unit from the turf area as quickly
as possible. To prevent possible damage to the turf,
immediately soak the affected area with water.
11

Install EU Decals

Parts needed for this procedure:
1 Warning decal (117–9537)
Procedure
If this machine will be used in the EU, affix the warning decal
117–9537 over English warning decal (117–9536).
12
Reading the Manuals and
Viewing the Training Materials
Parts needed for this procedure:
1 Operator's Manual (traction unit)
1
Engine Operator's Manual (engine)
1 Parts Catalog
1 Operator Training Materials
1 Pre-delivery Inspection Sheet
1 Noise rating certificate
1 Certificate of compliance
2 Ignition keys
Procedure
1. Read the manuals.
2. View the Operator Training Materials.
3. Store the documentation in a safe place.
21