Mounting The Front Rollers; Adjusting The Carrier Frame Rollers - Toro 04383 Operator's Manual

2-wheel drive traction unit

Hide thumbs Also See for 04383:

Operator's manual (44 pages)

Operator's manual (52 pages)

Operator's manual (40 pages)

Table Of Contents

Table of Contents

WARNING

Battery terminals or metal tools could short

against metal tractor components causing

sparks. Sparks can cause the battery gasses to

explode, resulting in personal injury.

• When removing or installing the battery,

do not allow the battery terminals to touch

any metal parts of the tractor.

• Do not allow metal tools to short between

the battery terminals and metal parts of

the tractor.

2. Connect the positive battery cable (red) from the

starter solenoid to the positive post (+) of the battery

(Figure 8). Secure it with a wrench and coat the

terminal with petroleum jelly. Make sure the cable will

clear the seat, in the rear-most position, which could

cause wear or damage to the cable.

Figure 8

1. Negative (-)

3. Connect the black ground cable to the negative (-) post

of the battery. Secure it with a wrench and coat the

terminal with petroleum jelly.

WARNING

Incorrect battery cable routing could damage

the tractor and cables causing sparks. Sparks

can cause the battery gasses to explode,

resulting in personal injury.

• Always disconnect the negative (black)

battery cable before disconnecting the

positive (red) cable.

• Always connect the positive (red) battery

cable before connecting the negative

(black) cable.

4. Place the terminal covers over the battery posts.

5. Install the battery clamp and covers and secure them

with the wing nuts.

2. Positive (+)