Optional Oil Cooler; Installing The Cutting Units (For Cutting Unit Models 04610, 04611 And 04616Only) - Toro 04383 Operator's Manual

6
Adjusting the Carrier Frame
Rollers
No Parts Required
Procedure
1. Position the machine on a level surface and lower the
cutting unit carrier frames to the floor.
2. Verify that there is 1/2 in. (13 mm) clearance between
the carrier frame rollers and the floor.
3. If an adjustment is required, loosen the jam nut on the
carrier frame stop screw (Figure 10) and rotate the
screw up or down to raise or lower the carrier frame.
Tighten the jam nut after adjustment is attained.
Figure 10
1. Carrier frame roller
7

Optional Oil Cooler

No Parts Required
Procedure
If you are operating the machine in hot climates, where
ambient temperatures range from 70 degrees F (20 degrees C)
2. Carrier frame stop screw
to 120 degrees F (49 degrees C), or using it for heavy-duty use
(mowing other than greens, such as fairways or verticutting),
install a Hydraulic Oil Cooler Kit, Part No. 104–7701, to the
machine.
8
Installing the Cutting Units
(For Cutting Unit Models
04610, 04611 and 04616Only)
Parts needed for this procedure:
1 Offset Lift Hook
2 Bolts, M10–1.5
1 Gauge bar
1 Bolt (#10 x 5/8 inch)
1 Jam nut (#10)
3
Cutting unit
6 Washer
6 Ball stud
3 Grass Basket
Procedure
Note: When sharpening, setting the height-of-cut or
performing other maintenance procedures on the cutting
units, store the cutting unit reel motors in the support tubes
to prevent damage to the hoses.
Important: Do not raise the suspension to the transport
position when the reel motors are in the holders in the
machine frame. Damage to the motors or hoses could
result
Important: Whenever the cutting unit has to be tipped
to expose bedknife/reel, prop up rear of cutting unit to
make sure nuts on back end of bedbar adjusting screws
are not resting on work surface (Figure 11).
17