Installing The Steering Wheel; Installing Breather Extension And Reservoir Cap; Mounting The Front Rollers - Toro 04383 Operator's Manual

1
Figure 4
1. Negative (–)

Installing the Steering Wheel

1. Slide the steering wheel onto the steering shaft.
3
1
Figure 5
1. Steering wheel
2. Jam nut
2. Secure the steering wheel to the shaft with the jam nut
(Fig. 5) and tighten it to 35 ft.-lb.
3. Install the cap to the steering wheel with the screw
(Fig. 5).
2
2. Positive (+)
2
3. Cap
Installing the Breather
Extension and Reservoir Cap
1. Remove the breather cap from the hydraulic reservoir
(Fig. 6).
3
1
Figure 6
1. Hydraulic reservoir
2. Breather cap
2. Thread the breather extension into the reservoir
(Fig. 6).
3. Thread the breather cap into the breather extension
(Fig. 6).
4. Remove and discard the shipping cap from the
hydraulic reservoir. Install the cap secured to the
machine.

Mounting the Front Rollers

1. Mount an anti-scalp roller and a pull link assembly to
the outer end of each front carrier frame with a roller
shaft, spacer, washer, and screw (Fig. 7). Make sure
the nylon bushing is in the pull link.
1
4
5
Figure 7
1. Pull link assembly
2. Pull link extension
3. Ball joint receiver
2. Make sure all tires are inflated to 8–12 psi.
2
4
3. Breather extension
4. Reservoir cap
3
2
6
4. Nylon bushing
5. Spacer
6. Washer
13