Installing Breather Extension And Reservoir Cap; Mounting The Front Rollers; Adjusting Carrier Frame Rollers; Installing The Cutting Units - Toro 04383 Greensmaster 3250-D Operator's Manual

Installing the Breather
Extension and Reservoir Cap
1. Remove the breather cap from the hydraulic reservoir
(Fig. 8).
3
1
Figure 8
1. Hydraulic reservoir
2. Breather cap
2. Thread the breather extension into the reservoir (Fig. 8).
3. Thread the breather cap into the breather extension
(Fig. 8).
4. Remove and discard the shipping cap from the
hydraulic reservoir. Install the cap secured to the
machine.

Mounting the Front Rollers

1. Mount an anti-scalp roller and a pull link assembly to
the outer end of each front carrier frame with a roller
shaft, spacer, washers and lock nut (Fig. 9). Make sure
the components are arranged as shown and the nylon
bushings are in the pull link.
1
5
7
2
Figure 9
1. Anti–scalp roller
2. Pull link assembly
3. Pull link extension
4. Ball joint receiver
2. Make sure all tires are inflated to 8–12 psi.
2
4
3. Breather extension
4. Reservoir cap
6
4
3
7
5
5. Washer (2)
6. Spacer
7. Nylon bushing (2)
Adjusting Carrier Frame
Rollers
1. Position the traction unit on a level surface and lower
the cutting unit carrier frames to the floor.
2. Verify that there is 1/2 in. (13 mm) clearance between
the carrier frame rollers and the floor.
3. If an adjustment is required, loosen the jam nut on the
carrier frame stop screw (Fig. 10) and rotate the screw
up or down to raise or lower the carrier frame. Tighten
the jam nut after adjustment is attained.
1
Right Front Shown
1. Carrier frame roller
Note: If you are operating the machine in hot climates,
where ambient temperatures range from 70_ F (20_ C) to
120_ F (49_ C), or using it for heavy-duty use (mowing
other than greens, such as fairways or verticutting), install a
Hydraulic Oil Cooler Kit, Part No. 104–7701, to the
traction unit.

Installing the Cutting Units

For Cutting Unit Models 04610 and 04611
Note: When sharpening, setting the height-of-cut, or
performing other maintenance procedures on the cutting
units, store the cutting unit reel motors in the support tubes
on the front of the frame to prevent damage to the hoses.
Important
Do not raise the suspension to the transport
position when the reel motors are in the holders in the
traction unit frame. Damage to the motors or hoses could
result.
15
2
Figure 10
2. Carrier frame stop screw