Installing The Steering Wheel; Installing The Breather Extension And Reservoir Cap; Mounting The Front Rollers - Toro 04383 Operator's Manual

Warning
Incorrect battery cable routing could damage the
tractor and cables causing sparks. Sparks can
cause the battery gasses to explode, resulting in
personal injury.
Always disconnect the negative (black) battery
cable before disconnecting the positive (red)
cable.
Always connect the positive (red) battery cable
before connecting the negative (black) cable.
1
Figure 6
1. Negative (–)

Installing the Steering Wheel

1. Slide the steering wheel onto the steering shaft.
3
1
Figure 7
1. Steering wheel
2. Jam nut
2. Secure the steering wheel to the shaft with the jam nut
(Fig. 7) and tighten it to 20–26 ft.-lb.
3. Install the cap to the steering wheel with the screw
(Fig. 7).
2
2. Positive (+)
2
3. Cap
15
Installing the Breather
Extension and Reservoir Cap
1. Remove the breather cap from the hydraulic reservoir
(Fig. 8).
3
1
Figure 8
1. Hydraulic reservoir
2. Breather cap
2. Thread the breather extension into the reservoir (Fig. 8).
3. Thread the breather cap into the breather extension
(Fig. 8).
4. Remove and discard the shipping cap from the
hydraulic reservoir. Install the cap secured to the
machine.

Mounting the Front Rollers

1. Mount an anti-scalp roller and a pull link assembly to
the outer end of each front carrier frame with a roller
shaft, spacer, washer, and screw (Fig. 9). Make sure the
nylon bushing is in the pull link.
1
4
5
Figure 9
1. Pull link assembly
2. Pull link extension
3. Ball joint receiver
2. Make sure all tires are inflated to 8–12 psi.
2
4
3. Breather extension
4. Reservoir cap
3
2
6
4. Nylon bushing
5. Spacer
6. Washer