Chapter 1 - Safety Information - Toro 38700 Service Manual

General Information
This symbol means WARNING or
!
PER SONAL SAFETY INSTRUCTION –
read the instruction because it has to do
with your safety. Failure to comply with
the instruction may result in personal
injury or even death.
This manual is intended as a service and repair manual
only. The safety instructions provided herein are for
troubleshooting, service, and repair of the Toro
Walk-Behind Rotary Broom.
Think Safety First
Avoid unexpected starting of engine...
Always turn off the engine and disconnect the spark plug
wire(s) before cleaning, adjusting, or repair.
Avoid lacerations and amputations...
Stay clear of all moving parts whenever the engine is
running. Treat all normally moving parts as if they were
moving whenever the engine is running or has the
potential to start.
Avoid burns...
Do not touch the engine, muffler, or other components,
which may increase in temperature during operation, while
the unit is running or shortly after it has been running.
Avoid fires and explosions...
Avoid spilling fuel and never smoke while working with
any type of fuel or lubricant. Wipe up any spilled fuel or
oil immediately. Never remove the fuel cap or add fuel
when the engine is running. Always use approved, labeled
containers for storing or transporting fuel and lubricants.
Avoid asphyxiation...
Never operate an engine in a confined area without proper
ventilation.
Walk-Behind Rotary Broom Service Manual
SAFETY INFORMATION
The Power Clear operator's manuals contain safety
informa tion and operating tips for safe operating practices.
Operator's manuals are available online through your Toro
parts source or:
The Toro Company
Publications Department
8111 Lyndale Avenue South
Bloomington, MN 55420
Avoid injury from batteries...
Battery acid is poisonous and can cause burns. Avoid
contact with skin, eyes and clothing. Battery gases can
explode. Keep cigarettes, sparks and flames away from
the battery.
Avoid injury due to inferior parts...
Use only original equipment parts to ensure that important
safety criteria are met.
Avoid injury to bystanders...
Always clear the area of bystanders before starting or
testing powered equipment.
Avoid injury due to projectiles...
Always clear the area of sticks, rocks or any other debris
that could be picked up and thrown by the powered
equipment.
Avoid modifications...
Never alter or modify any part unless it is a factory
approved procedure.
Avoid unsafe operation...
1-1