Specifications; General Specifications; Controls - Toro 09802 HydroJect 3010 Operator's Manual

Hide thumbs Also See for 09802 HydroJect 3010:
Table of Contents

Advertisement

Specifications

Note: Specifications and design subject to change without notice.

General Specifications

Engine
Clutches
Electrical
Traction Drive
Tires/Wheels
Brake
Transport Lift
Fuel Capacity
Ground Speed
Aeration Width
Aeration Depth
Hole Pattern

Controls

Engine Panel
Steering Tiller Panel
Electronic Control Module
Kohler, 4 cycle, V–twin, air cooled, 27 hp @ 3600 RPM, 44 cu. in (725 cc)
displacement. Electric start. Heavy duty air cleaner. 2 quart oil capacity. Solid state
ignition. Meets California Exhaust Emission Standard and EPA Standards for Lawn
and Garden Equipment.
Electromagnetic, dual groove belt drive for water pump and drive shaft flange
brake/clutch for main valve gearbox.
12 volt system with 15 amp circuit breaker protection. Relays for all high current
switching. Electronic controller and sensors for automatic startup and shutdown
sequence of water injection system. Group 28 battery with 535 cold crank amps.
Closed loop hydrostatic drive consisting of Sundstrand variable volume pump and
Parker low speed, high torque wheel motor mounted to steering fork. Hydraulic
system contains 5 quarts with 25 micron suction line filter and gearbox reservoir.
Three, smooth tread 2 ply, 18 x 9.50-8,pneumatic tubeless, tires. De–mountable
drop center steel wheels with 4 lug nuts mounted to tapered roller bearing hubs on
transport arms and brake hub on wheel motor. All are interchangeable.
Drum and shoe-type parking brake mounted to wheel motor. Holds unit on a 30%
grade.
12 volt Warner Electric linear screw actuator with 6 inch stroke. Raises and lowers
lift arm/transport tires and activates hole spacing control.
10.5 gallons gasoline
Aerating: 0–2 MPH (both directions)
Transport: 0–4 MPH (both directions)
33 inches with 11 nozzles on 3 inch centers
4 to 6 inches depending on turf conditions and nozzle configuration
Variable from 1-1/2 to 6 in. spacing in the direction of travel, and 3 or 6 in.
increments in width
Throttle, choke, spray wash control, hour meter, water pressure gauge, spacing
control lever, key switch, and circuit breaker reset button
Traction bail, water system engage and disengage buttons, transport/aerate lift
rocker switch, and parking brake with buzzer alarm.
Solid state potted device for sequencing start and stop of water system. Interlocks
for water pressure, transport lift, traction neutral and accumulator over–pressure.
9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hydroject 3010

Table of Contents