Troubleshooting - Toro 09802 HydroJect 3010 Operator's Manual

Troubleshooting

Problem
The unit will not move when the
traction ball is engaged.
The unit will not transport at full
speed.
The engine dies during startup.
Possible Causes
1. Check that motion occurs at the
pump pivot plate when the
traction ball is moved.
2. The oil level in the hydraulic
reservoir (gearbox) is low.
3. Bypass valve is not fully closed.
4. The traction drive belt tension
is incorrect.
1. The unit is not fully raised to
the transport position.
2. The oil level in the hydraulic
reservoir (gearbox) is low.
3. Bypass valve is not fully closed.
4. The traction drive belt tension
is incorrect.
5. Check that motion occurs at the
pump pivot plate when the
traction ball is moved.
1. The fuel shut-off valve is
closed.
2. Fuel in the fuel tank is low.
3. The engine choke is not
operating correctly.
4. Check the engine oil level.
5. Starting conditions are cold
(30°).
35
Corrective Action
1. Inspect the traction push/pull
cable and override assembly
under the tiller handle.
2. Replenish, if necessary.
3. Close the valve.
4. Adjust the belt tension.
1. Hold the lift toggle switch until
the slip clutch in the actuator
can be heard ratcheting and
the spindle lift arms are nearly
vertical with the rear axle
spindle tipped away from the
engine.
2. Replenish, is necessary.
3. Close the valve.
4. Adjust the belt tension.
5. Inspect the traction push/pull
cable and override assembly
under the tiller handle.
1. Open the fuel shut-off valve.
2. Replenish, if necessary.
3. Check the choke connections
and operation. Regulate the
choke until the engine is warm
when starting a cold engine.
4. The oil pressure switch is
bypassed during start, but must
activate to protect the engine
while running.
5. Multiple start attempts may be
required to trip the oil pressure
switch.