Toro 09802 HydroJect 3010 Operator's Manual page 36

Problem
The engine dies when the water
system is engaged. y g g
The engine does not start (will not
engage the starter). g g )
The engine is running and the unit
is not producing aeration holes
(the pump or water valve will not
start). )
Possible Causes
1. The throttle is in the wrong
operating position.
2. The engine speed is set
incorrectly.
3. Engine power is low.
1. The traction bail is not in the
neutral position.
2. The neutral switch tab is out of
adjustment.
3. The battery voltage is low.
4. There is a malfunction is the
electrical system.
1. The supply hose is kinked,
there is a restriction in the line,
or the valve at the water source
is only partially opened.
2. There is inadequate water
pressure or flow from the
source.
3. Check the water pressure at
the gauge when the pump is
engaged if the water pressure
drops to less than 25 psi, but
was initially higher.
4. Low accumulator pre–charge
pressure (low pressure
indicator light is on) .
5. High accumulator pre–charge
pressure (high pressure
indicator light is on) .
36
Corrective Action
1. Put the throttle in the FAST
position when aerating.
2. Adjust the carburetor fast
setting to 3450–3550 RPM.
3. Fuel is contaminated, there is a
plugged fuel filter or air filter, or
there is a bad spark plug.
4. Have the system serviced by
an Authorized Toro Distributor.
1. Correct the traction bail
position.
2. Adjust the switch tab until the
red traction light is OFF in
neutral.
3. Check the battery.
4. Check the circuit breaker and
electrical connections.
1. Correct the condition.
2. Check the water pressure (from
the water source) at the inlet
(8 gpm – 40 psi).
3. Replace the water filter.
4. Have the system serviced by
an Authorized Toro Distributor.
5. Have the system serviced by
an Authorized Toro Distributor.