Servicing The Spray Wash Nozzles Or Strainers; Caring For The Battery - Toro 09802 HydroJect 3010 Operator's Manual

Hide thumbs Also See for 09802 HydroJect 3010:
Table of Contents

Advertisement

3
5
4
2
1
Figure 36
1. Fitting cap
2. Nozzle
3. Fitting
Servicing the Spray Wash
Nozzles or Strainers
To clean or replace the strainers in the spray wash nozzles,
proceed as follows:
1. Loosen and remove the cap on the bottom of the fitting
(Fig. 36).
2. Remove the nozzle and strainer assembly (Fig. 36).
Clean or replace the strainer and replace it in the nozzle.
3. Loosely secure the nozzle and strainer to the fitting with
the cap.
4. Rotate the nozzle so that slot in the tip is parallel to the
roller.
5. Tighten the cap and check the adjustment.

Caring for the Battery

If the aerator is stored in a location where temperatures are
extremely high, the battery will run down more rapidly than
if the machine is stored in a location where temperatures
are cool.
Keep the top of the battery clean by washing it periodically
with a brush dipped in ammonia or bicarbonate of soda
solution. Flush the top surface with water after cleaning.
Do not remove the fill caps while cleaning.
The battery cables must be tight on the terminals to provide
good electrical contact.
If corrosion occurs at the terminals, disconnect the cables,
negative (–) cable first, and scrape the clamps and terminals
separately. Reconnect the cables, positive cable first, and
coat the terminals with petroleum jelly.
3
4. Strainer
5. Hex. nut
Incorrect battery cable routing could damage the
aerator and cables causing sparks. Sparks can
cause the battery gasses to explode, resulting in
personal injury.
• Always disconnect the negative (black) battery
cable before disconnecting the positive (red)
cable.
• Always connect the positive (red) battery cable
before connecting the negative (black) cable.
If the machine will be stored more than 30 days, remove
the battery and place it on trickle charge. Either store it on
the shelf or on the machine. Leave the cables disconnected
if it is stored on the machine. Store the battery in a cool
atmosphere to avoid quick deterioration of the charge in the
battery.
33
Warning

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hydroject 3010

Table of Contents