Depths And Nozzle Configurations - Toro 09802 HydroJect 3010 Operator's Manual

Depths and Nozzle Configurations

All nozzles are identified with numbers indicating the drill size of the orifice. The standard configuration is 11 nozzles
producing depths of 4 to 6 inches depending on turf conditions. Blocked nozzle locations are obtained by reversing the nozzle
check valve ball and spring. See nozzle size chart and illustrations below:
Important
Use only nozzle configurations shown or damage to the machine may occur.
Part No Part No.
86-8130
86-8131
86-8133
* Use only with varied size configurations
Note: Aluminum Washer, Toro Part no. 80-6680, is required with any nozzle change.
Part No. Part No
86-8130
86-8133
** Additional nozzles may be blocked to compensate for pump wear.
Note: Aluminum Washer, Toro Part no. 80-6680, is required with any nozzle change.
Check Valve Ball
Spring
Nozzle Size and Approximate Depth Chart
Decimal Decimal
Drill Size Drill Size
Size (inch)
#56 0.0465
#53 0.0595
#46 0.081
Optional Staggered Size Nozzle Configuration
Decimal Decimal
Drill Size Drill Size
Size (inch)
#56 0.0465
#46 0.081
Open Nozzle
Quantity of Nozzles
Metric Size Metric Size
(mm)
Open
1.181 *
1.511 11
2.057 6
Quantity of Nozzles
Metric Size Metric Size
(mm)
Open
1.181 6 and
2.057 5
Spring
Check Valve Ball
Closed (Blocked) Nozzle
11
Approx. Approx.
Depth
Blocked
* *
0 4–6 in.
5 6–8 in.
Approx. Approx.
Depth
Blocked**
0** 3–4 in.
0** 6–8 in.