NorthStar GM1708 961X Installation Manual page 50

SECTION TWO - Installation
Table 3: Troubleshooting the GPS/DGPS antenna installation (continued)
Antenna Symptom
DGPS ANTENNA No beacon signal (applies to all DGPS
(cont'd) antennas):
If the
If the coax and antenna are okay and there
is 7.75 VDC:
Page 40
BCN RCVR ST
reads "failed:"
Possible Solutions/Reasons
STAR
•
Press the key to display the
SETUP MENU
screen, then press
RECEIVER SETUP
the
DGPS SYSTEM
that the
BEACON FREQ
options are set to
BAUD RATE
"on," and that the
option is set to "auto."
STAR
•
Press the key to display the
SETUP MENU
screen, then press
PRODUCT INFO
the
BCN RCVR ST
that the
PASSED
" ."
•
Check the coax and antenna for open/
short, and check for 7.75 VDC at the
UHF connector, under load.
•
The 1710 board in the processor may
be bad.
961 INSTALLATION MANUAL Revision A
key. Check
option and
key. Check
reads