Ignition Control - Ignition On; Thor Vm2 Is Off And Vehicle Ignition Is Switched To On; Thor Vm2 Is On And Vehicle Ignition Is Switched To On - Honeywell THOR VM2 Reference Manual

Ignition Control - Ignition On

Select either the Ignition Control - Ignition On or the Ignition Control - Ignition Off power scheme when ignition control of the
Thor VM2 power on process is desired.
The Thor VM2 aromatically switches between the Ignition Control - Ignition On or the Ignition Control - Ignition Off power
schemes depending on the state of the vehicle ignition input.
The following default timeouts are used in the Ignition Control - Ignition On power scheme.
Plugged In
Setting (AC or DC
Turn off monitor 30 minutes
Turn of hard disks 30 minutes
System standby
System hibernate
The ignition input wire must be connected. If the user selects this power scheme but the ignition is Off, the Ignition Control -
Ignition Off scheme is used instead.
When either Ignition Control Power Scheme is selected and external power is present the Thor VM2 behaves as described
below. If external power is not present, refer to the

Thor VM2 is Off and Vehicle Ignition is Switched to On

Conditions
The Thor VM2 is Off and vehicle ignition changes from Off to On.
Result
The Thor VM2 boots. Once booted the Thor VM2 follows the Ignition Control/Ignition On power scheme with timers reset
after the boot completes.

Thor VM2 is On and Vehicle Ignition is Switched to On

Conditions
The Thor VM2 is On and vehicle ignition changes from Off (or not present) to On.
Result
The Thor VM2 continues to run and follows the Ignition Control/Ignition On power scheme with timers reset at the time
Ignition switched to Active.
An example of this case would be a Thor VM2 that is running on UPS and is then mounted on a Dock that has truck power and
the ignition switch is already On.
Running on
Batteries
Power) (UPS Power)
1 minute
1 minute
5 hours 10 minutes
Never 20 minutes
UPS section for Thor VM2 behavior.
3-27