Ac/Dc; Thor Vm2 Is Off; Thor Vm2 Is On - Honeywell THOR VM2 Reference Manual

AC/DC

Select the AC/DC power scheme when manual control of the Thor VM2 power on process is desired.
This is the default power scheme. In AC/DC mode the Thor VM2 is turned on by a press of the Power button. Ignition input is
ignored when AC/DC Mode is enabled.
The following default timeouts are used in the AC/DC power scheme.
Plugged In
Setting (AC or DC
Turn off monitor 30 minutes
Turn of hard disks 30 minutes
System standby
System hibernate
When the AC/DC Power Scheme is selected and external power is present the Thor VM2 behaves as described below. If
external power is not present, refer to the

Thor VM2 is Off

Conditions
The Thor VM2 is Off and external power is available, such as:
Thor VM2 is installed on a powered Quick Mount Smart Dock with the Dock power switch On
l
Thor VM2 is already mounted to a Dock and external power is applied to the Dock
l
Result
The Thor VM2 boots when the Power button is pressed. Once booted the Thor VM2 follows the AC/DC power scheme with
timers reset after bootup.

Thor VM2 is On

Conditions
The Thor VM2 is On (but powered by the UPS battery) and gets external power, such as:
Thor VM2 is installed on a powered Dock with the Dock power switch On
l
Thor VM2 is already mounted to a Dock with the Dock power switch On and truck power is applied to the Dock
l
Thor VM2 is already mounted to a Dock and the Dock power switch is turned On
l
Result
The Thor VM2 continues to run and follows the AC/DC power scheme with timers reset at power connection.
Running on
Batteries
Power) (UPS Power)
1 minute
1 minute
5 hours 10 minutes
Never 20 minutes
UPS section for Thor VM2 behavior.
3-26