Installation - HIKVISION DS-2CD883F-EW Installation Manual

Installation Manual of Network Camera
 To reset the default parameters to the camera, you need to press and hold the reset button and
power on the camera. After the power on the camera, you must still press and hold the reset
button for about 10 seconds.
 The DS-2CD2612F-IS and DS-2CD2632F-IS models support audio and alarm functions. The
interfaces are shown as follows.
4.5.2

Installation

Before mounting, please make sure that the device in the package is in good condition and all the
assembly parts are included.
Notes:
 Please make sure that the device in the package is in good condition and all the assembly parts
are included.
 Check the specification of the products for the installation environment.
 Make sure that all the related equipment is power-off during the installation.
 Check whether the power supply is matched with your AC outlet to avoid any damage.
 If the product does not function properly, please contact your dealer or the nearest service center.
Do not disassemble the camera for repair or maintenance by yourself.
 Please make sure that the wall is strong enough to withstand three times the weight of the
camera
SD Card Installation
Steps:
1. Rotate the TW M3X5 screw counterclockwise about 3 to 4 rounds to loosen it. Slide the sun
shield according to the arrow direction as shown in Figure 4-26(left).
2. Remove the sun shield according to the arrow direction as shown in Figure 4-26(right).
3. Remove the front cover by rotating it counterclockwise as shown in Figure 4-26(right).
Figure 4-25 Audio and Alarm Interfaces
68
Audio
Alarm