Installation - HIKVISION DS-2CD883F-EW Installation Manual

Installation Manual of Network Camera

4.2.2 Installation

These bullet cameras can be installed to wall. Please refer to the steps below for installation.
Steps:
1. Attach the wall mount(not provided) to the wall and tighten the screws to fix it.
Notes:
 The wall mount should be longer than 1/2 of the camera length.
 For cement wall mounting, you need to use the expansion screw to fix the bracket. The mounting hole of
the expansion pipe on the wall should align with the mounting hole on the bracket.
 For wooden wall mounting, you can just use the self-tapping screw to fix the bracket.
 The wall must be strong enough to withstand more than 3 times the weight of the camera and the
bracket.
2. Secure the camera to the wall mount with set screws.
3. Route the cables for the camera as shown follows.
Figure 4-11 Overview
Table 4-2 Description
No. Description
1 10M/100M self-adaptive Ethernet interface
2 Power supply
3
4 Adjusting screw
Figure 4-12 Install the Wall Mount
Sun shade
61