Extending Range Of A Network With A Repeater Hop - Honeywell XYR 400E User Manual

Set dipswitch to RUN.
Click on button Save to Flash and Reset. Webpage will display that message indicating details
are being written to flash. Wait for XYR 400E to reboot before removing power. Enter a System
Generator String
Client Configuration
Perform the same configuration steps as the Access Point configuration with the following
differences:
Enter "Network", and select Operating Mode as Client.
Device Mode should be set to Bridge.
Set the Gateway IP address to 169.254.102.54
Set the Ethernet IP address to 169.254.102.53, network mask 255.255.255.0
Set the Wireless IP address to 169.254.102.53, network mask 255.255.255.0
Click on button Save to Flash and Reset. Webpage will display that message indicating details are
being written to flash. Wait for XYR 400E to reboot before removing power.

Extending range of a network with a Repeater hop

192.168.0.0
255.255.255.0
LAN
Configure units as described in Section Extending a wired network . Place the Access Point at the
remote intermediate repeater location. Additional repeaters can be added using Wireless
Distribution System (WDS) – refer section 3.10 Repeater Configuration for further details.
Version 1
5/1/08
Access
Client 1
XYR400E Ethernet Modem
Point
Client 2
64