Honeywell XYR 400E User Manual page 37

Wireless ethernet modem
Table of Contents

Advertisement

specified if there are multiple Access Points with the same SSID. Finally, in this example we
demonstrate the flexibility of the XYR 400E by specifying different Encryption on only one of the
WDS links.
In the example below, 4 Access Points (A, B, C, and D) form a mesh network using only WDS
bridge interfaces. Each of the Access Points may also have its own clients associated. Each Access
Point also has the same SSID, meaning the clients can roam freely throughout the mesh network and
also that WPA encryption may easily be used. A, B, C, and D can all exchange data with each other
(as can all of their clients) as if they were all on the same wired segment. It can bee seen that there
are redundant paths and therefore the possibility for loops to occur, so that the bridge Spanning Tree
Protocol should be enabled. To illustrate the redundancy, consider that if A needs to send data to D
it has redundant paths through both B and C. However, due to the spanning tree protocol only one
of B or C will relay the data, with the other taking over in the event of a failure.
Access Point
192.168.0.2
A
The configuration for unit A is shown below (this page is accessible via the Repeaters link from the
configuration web pages). It can be seen that "WDS" mode and "Bridge Spanning Tree Protocol"
are enabled, and "Auto Connect to WDS enabled AP's" is selected. Note that auto connect mode
requires that none of the Access Points disable their "SSID broadcast", otherwise they must have the
same SSID. If this is not the case the connections must be manually entered into the WDS
connection list (described later).
"Inherit default encryption" has also been selected – thus allowing us to inherit the same encryption
mode used for the default wireless interface (i.e. the interface used to communicate with clients). If
WPA encryption is inherited, then all Access Points must have the same SSID otherwise the list of
possible allowed Access Points (by SSID) and their corresponding passphrases must be specified in
the connection list since WPA Pre-Shared Keys are derived from both passphrase and SSID.
37
Access Point
192.168.0.3
B
C
Access Point
192.168.0.4
XYR400E Ethernet Modem
Access Point
192.168.0.5
D
Version 1
5/1/08

Advertisement

Table of Contents
loading

Table of Contents