Honeywell XYR 400E User Manual page 41

Wireless ethernet modem
Table of Contents

Advertisement

Enable AP's
Only connect to AP's in list
Maximum WDS connections
to this device
WDS Connections:
SSID
MAC Address
Encryption
Passphrase
Router IP
Router Subnet
STP
41
even if those Access Points are not present in the list (NOTE – requires
that Access Points that are not in the list do not have "SSID broadcast"
disabled, otherwise the SSID is assumed to be the same as this Access
Point; Auto connect interfaces will always be bridged with the default
wireless interface).
Only attempt to establish WDS links with Access Points identified in the
list.
Each XYR 400E Access Point supports a maximum of 6 WDS links
direct to other Access Points. However the maximum may be reduced –
this can be useful when Auto Connect is used.
Specify the SSID of the Access Point(s) to establish a WDS link with.
Leave this field blank if you wish to nominate the Access Point by
MAC address only – however in that case the Access Point must not
have "SSID broadcast" disabled.
Specify the MAC address of an Access Point to establish a WDS link
with. Leave this field blank if you wish to connect to any Access Point
with the nominated SSID
Select the required Encryption (if any) for this WDS link. If WEP
Encryption is required WEP must also be enabled for the default
wireless interface – and the same WEP key will be inherited.
When WPA Encryption is selected, enter the WPA passphrase for this
WDS link here.
Leave this field blank if this WDS interface is to be bridged with the
default wireless interface. Otherwise enter the IP address for this Access
Point that specifies the IP network to route messages to.
Leave this field blank if this WDS interface is to be bridged with the
default wireless interface. Otherwise enter the subnet mask of the
network to route messages to.
Applicable to WDS Router interfaces only. If two or more WDS router
interfaces having the same Router IP Address and Subnet mask become
active the XYR 400E must internally bridge them. Select the STP
option if you wish to enable the bridge Spanning Tree Protocol for the
bridge if this interface is added.
XYR400E Ethernet Modem
Version 1
5/1/08

Advertisement

Table of Contents
loading

Table of Contents