Table of Contents
Advertisement
connected to the PC. Alternatively the program telnet may be used to connect to a serial port on the
XYR 400E. The telnet command used should be:
TELNET [IP address] [Listen Port]
eg. TELNET 192.168.0.155 23 where the IP address is 192.168.0.155 and Listen Port is 23.
Enable RS-232 PPP Server
Enable RS-485 Serial
Gateway
Data Rate
Data Bits Parity Stop Bits
Character Timeout
Server
Listen Port
Client
Remote Device Port
Remote Device IP Address
Multicast Group Port
Multicast Group IP
53
Check this box to enable the PPP network server on the RS-232 port.
Check this box to enable the Serial Gateway Server on the RS-485 port.
The serial data rate desired. Serial data rates available range from
110bps to a maximum of 115,200bps.
The data format desired. Data formats of 8N1, 7E1, 7O1, 7E2, 7O2 are
supported.
Enter the maximum delay (in msec) between received serial characters
before packet is sent via network.
When configured as Server, the module will wait for a connection
to be initiated by a remote client
Server Only. Enter the TCP port number on which the server must listen
for incoming connections. The standard TELNET port is 23.
When configured as Client, the module will automatically attempt
to connect to the specified remote server
Client only. Enter the TCP port number of the remote server (i.e.
the remote port to automatically connect to).
Client only. Enter the IP Address of the remote server (i.e. the
remote IP Address to automatically connect to).
Enter the UDP port number that all members of the group will use
(i.e. all group members should use the same port number).
Enter a valid Multicast IP Address identifying the group (i.e. all
group members should use the same Multicast Group IP Address).
Valid Multicast IP Addresses are in the range 224.0.1.0 to
238.255.255.255.
XYR400E Ethernet Modem
Version 1
5/1/08
Advertisement
Table of Contents
