Table of Contents
Advertisement
192.168.0.34
192.168.0.34
LAN A
1.2
Most applications for the XYR 400E require little configuration. The XYR 400E has many
sophisticated features, however if you don't require these features, this section will allow you to
configure the units quickly.
First, read Section 2, "Installation". The XYR 400E requires an antenna and a power supply.
Power the XYR 400E and make an Ethernet connection to your PC (for further information on
how to do this, refer to section 3.4)
Set the XYR 400E address settings as per section 3.4
Save the configuration - the XYR 400E is now ready to use.
Before installing the XYR 400E, bench test the system. It is a lot easier to locate problems when the
equipment is all together.
There are other configuration settings which may or may not improve the operation of the system.
For details on these settings, refer to section 3.
Chapter Two
2.1
The XYR 400E module is housed in an rugged aluminium case, suitable for DIN-rail mounting.
Terminals will accept wires up to 2.5 sqmm (12 gauge) in size.
All connections to the module must be SELV. Normal 110-250V mains supply should not
be connected to any terminal of the XYR 400E module. Refer to Section 2.3 Power Supply.
Before installing a new system, it is preferable to bench test the complete system. Configuration
problems are easier to recognize when the system units are adjacent. Following installation, the
most common problem is poor communications caused by incorrectly installed antennas, or radio
11
Access Point
Bridge
192.168.0.74
169.254.109.40
Client
Router
XYR400E Ethernet Modem
192.168.0.72
Client
Bridge
192.168.0.73
Client
LAN B
Router
Getting Started Quickly
INSTALLATION
192.168.0.72
169.254.102.17
LAN C
General
Version 1
5/1/08
Advertisement
Table of Contents
